Haier AB122MCERA Operation Manual - Page 14
Light
View all Haier AB122MCERA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Operation instruction AUTO, COOL , HEAT and DRY Operation (1) Unit start Press ON/OFF button, the unit starts. Previous operation status appears on LCD (except for A TIMER,SLEEP and SWING setting) 2qc TEMP • 3 ON 3 S NG 5 1 4 MODE SLEEP 2 TH FRESH fn SET TIMER HIGHISO ,_CD CV), 0 FILTER cllE- A)1 ) LIGHT RESET CODE 5 3 • • (2) Select operation mode Press MODE button. Each press, the operation mode changes as follows: Code A [AUTOC7 i i• COOL DRY HEAT FAN] Then select AUTO, COOL, DRY or HEAT as needed. (3) Temperature setting Press TEMP button. A Every time the button is pressed, the setting temperature increases by 1°C; if the button is kept pressed, the setting temperature will increase quickly. V Every time the button is pressed, the setting temperature decreases by 1°C, if the button is kept pressed, the setting temperature will decrease quickly. Set the proper temperature. (4) Adjust fan speed Press FAN button. Each press, the fan speed changes as follows: Code A AUTO LOW MID HIGH Air conditioner will run at the selected fan speed. (5) Unit stop Press ON/OFF button, the unit stops. COOL operation starts NOTE: when room temp.is higher than temp. setting. In FAN mode, the temperature setting is not displayed on LCD. Ultra-low air flow • In DRY mode, when room temperature becomes Temp. setting +2°C Temp.setting 2°C higher than temperature setting, unit will run intermittently at LOW speed regardless of FAN setting. When room temperature is lower than temperature On reaching temp.setting setting, unit will only run FAN operation. +2°C, unit will run in mild • In HEAT mode, warm air will blow out after a short DRY mode. period of time due to cold-draft prevention function. 12