Haier HBF05EBSS Product Manual - Page 7
Proper Location, Electrical Connections - dimensions
UPC - 688057300108
View all Haier HBF05EBSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
English Proper Location • To ensure that your beer dispenser works at the maximum efficiency it was designed for, install it in a location where there is proper air circulation, plumbing and electrical connections. • Choose a location where the beer dispenser will be away from heat and will not be exposed to direct sunlight. • This beer dispenser is designed for indoor use only and should not be used outdoors. • This beer dispenser is a freestanding design and should not be placed in a built-in or recessed area. • The following dimensions are the recommended clearances around the beer dispenser. Sides 3/4" (19mm) Back 1" (25mm) ELECTRICAL CONNECTIONS Grounding Instructions This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord containing a grounding wire and a grounded plug. The plug must be inserted into an outlet that is properly installed and grounded. • Improper use of the plug may result in the risk of electric shock. • Consult a qualified electrician or service technician if the grounding instructions are not completely understood or if in doubt as to whether the appliance has been properly grounded. Wiring Requirements This appliance must be plugged into a 15Amp, 115 Volt, 60Hz GROUNDED OUTLET. Note: Where a standard two-prong outlet is encountered, it is the personal responsibility and obligation of the consumer to have it replaced with a properly grounded three-prong outlet. Extension Cords We do not recommend the use of an extension cord with this unit. Power Interruptions Occasionally, there may be power interruptions due to thunderstorms or other causes. Remove the power cord from wall outlet when a power outage occurs. When power has been restored, re-plug the power 6 cord into wall outlet.