Haier HBF05EBSS Product Manual - Page 8

English Assembly Instructions Read carefully and understand all installation instructions before installing the beer dispenser. If after completing the process you are still unsure whether the beer dispenser has been properly installed, we recommend that you contact a qualified installer. Installing the Casters Nut Follow the steps below to install the casters. 1. Empty the inside of the cabinet completely and lay the beer dispenser down sideways. We recommend that you place a piece of cardboard or cloth underneath the cabinet to prevent dents or scratches to the cabinet. Caster Wrench 2. Insert the casters into the holes on the bottom corners of the cabinet. Tighten each caster by turning the nut clockwise with the wrench provided. 3. Once all four casters have been tightened evenly, stand the cabinet in an upright position. Installing the Beer Tap Follow the steps below to install the beer tap. 1. First, remove the cabinet tap hole cover located on the worktop. Firmly grasp cover, twist and pull upward. Handle Note: Store this plug in a safe place as it will be required when converting the beer dispenser into a beverage center. 2. Place the gasket over the hoses on the bottom of the draft arm. Large Philip Head Gasket Beer Hose Draft Arm Assembly Small Phillips Head 3. Pass the beer tubes through the gasket to the base of the draft arm. 4. Push both the hoses and the beer hose through the hole in the worktop until the draft arm is resting on top of the cabinet. Guard Rail pilot holes 5. Align the holes of the draft arm with the gasket and pilot holes on the worktop of cabinet. Make sure that the faucets are facing the front. 6. Secure the draft arm to the cabinet by inserting four large Phillips Head screws into the holes and tightening. 7