Haier HDC2406TW HDC2406TW Manual - Page 11

English Drain hose: This unit has a special grey drain hose included. If you choose a permanent installation you must connect this hose to the dishwasher drain threaded connector. Use one hose clamp supplied. Hose connections for permanent installation Back of Dishwasher Sink Drain Sink Drain Change intake valve to standard Back of Dishwasher 3/4 inch dishwasher inlet hose To the Sink HOT water pipe Water Hose DishwasherTaiTl oPitphee Sink HOT water pipe (Not Included) Special Grey Drain Hose Purchased hose clamp Grey "L" Hose to dishwasher drain connector Place clamp here; insure no leakage Instruction: This should be done by a professional and qualified installer 1. Decide the best location to run the hoses under the sink. Make sure both hoses will reach before cutting into counter top. 2. The quick connect faucet adapter and hoses must be removed from the unit for both the intake and drain connections. 3. Change the intake hose to a 3/4 inch and secure tightly. 4. Using the special grey hose supplied, tighten hose to the drain connector. 5. Run both hoses below the sink and attach as a permanent installation for water intake and drainage. The special drain hose should be attached at one end to the dishwasher, at the other end to the sink tail pipe (not included), and secured at both ends with a clamp (one clamp provided). Note: The intake hose should be connected to the HOT water pipe. The drain hose should be below the height of the base of the dishwasher. 6. Test the water connections to insure that there are no leaks 7. Connect dishwasher to a 120v household, grounded outlet. 10