Haier HDP18PA User Manual - Page 26

Note: If for any reason the dishwasher malfunctions during the operation, follow the steps below to drain the water out, I) Shut off the dishwasher and wait few seconds. 2) Turn on the power again by pressing power button. Press Start/Pause button. After few seconds drain pump will come on for short period of time twice. You will hear some type drain pump noise in the dishwasher, Observe if the drain hose is pumping water out in to the sink. 3) Immediately turn off the dishwasher after the second drain, 4) If there is still water left in the dishwasher, repeat first three steps again until the water is removed completely, Water is not pumping out of the tub: • Drain is clogged. Make sure that your kitchen sink is draining well. If not, call a plumber. Dishwasher is leaking: • Dishwasher is not leveled properly. You need to place the dishwasher on the flat hard surface, Avoid uneven surface, • The tub may be cracked, If the tub is cracked then you need to call for service. Dishwasher will not fill: • Check water supply. Make sure that water supply is at "On" position instead of "Off" position, • Check water pressure. Make sure the water pressure is at proper level. (Between 20 - 120 PSI) Water found under the filter: This is normal, After water is drained out, a small amount of water found under the filter area due to different settings and shapes of food containers in the lower rack. The water will be drained out first in next wash operation automatically. 25