Haier HLTD500AGW User Manual - Page 14
Gas Supply Connection Requirements
![]() |
View all Haier HLTD500AGW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
GAS SUPPLY REQUIREMENTS NOTE: The gas service to the dryer must conform with local codes and ordinances and the latest edition of the National Fuel Gas Code, ANSI Z223.1 or in Canada, CAN/CGA B149.1. Natural Gas r The dryer is equipped for use with Natural gas. LP (Liquid Propane) Gas r The dryer can be converted for use with LP gas. r Conversion to LP gas must be made by a qualinjed technician. Gas Supply Line r The gas supply line should be ½" (1.3 cm) pipe and must have an individual manual shutoNj valve installed within 6 ft (183 cm) of the dryer in accordance with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or in Canada with the Natural Gas and Propane Installation Code, B149.1. r The shutoNj valve should be easy to reach for opening and closing. r A ƌ" NPT minimum plugged tapping, accessible for test gage connection, must be installed immediately upstream of the gas supply connection to the dryer. r The supply line should terminate with a ƍ" NPT Ǎare adapter njtting. ½" NPT Gas Supply Line Gas ShutoNj Valve ƌ" NPT Minimum Plugged Tapping ƍ" NPT Flare Adapter Fitting A B C D GAS SUPPLY CONNECTION REQUIREMENTS This dryer must be connected to the gas supply line with a listed Ǎexible gas connector that complies with the standard for connectors for gas appliances, ANSI Z21.24 or CSA 6.10. Flexible stainless steel gas connector: r If local codes permit, use a new Ǎexible stainless steel gas connector (Design Certinjed by the American Gas Association or CSA International) to connect your dryer to the rigid gas supply line. Use an elbow and a ƍ" Ǎare x ƍ" NPT adapter njtting between the stainless steel gas connector and the dryer gas pipe, as needed to prevent kinking. 12
![](/manual_guide/products/haier-hltd500aew-user-manual-54b785c/14.png)