Haier HWM80-68B User Manual - Page 16

Disposal after washing After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Please take off the detergent box and wash it The lint filter must be used during with water washing. 1.How to take it off: Pull it upwards slantingly and gently. It must be cleaned in time after each using Lint filter: 2.How to install: Put it in from the top slantingly, 1.Pull it up to dismantle. then push it in to the right position. 2.Push it down to install. 3.Clean the filter screen after washing. Dismount Install The filter screen of the water inlet valve is likely to be blocked by foreign materials and influence the water inlet. Please clean it with brush every two months. Dismantle Install Clean If the cabinet is dirty, wipe it with wet cloth Do not flush it directly with water. Wipe it with neutral detergent. Do not wipe it with thinner, petrol, alcohol etc. Petrol Thinner Alcohol 1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose). 2.Do not store water in the washing machine for a long period. Drain the water completely after each using. 3.Be sure to pull off the power plug before maintenance. 4.Hang up the power cord and drain hose. 5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time (about 1 hour), then close the top lid. Answers to question Common phenomena Phenomena Explanation The spinning is intermittent when it starts. Push the SPIN button,but it doesn't act. It is to balance the laundries to avoid slanting. The program issetting the draintime. Acertain period is needed before it starts spinning. The pulsator pauses during water filling in washing and rinsing. There may be some water flowing out of the drain hose in the first use of the machine. In adding water, the pulsator performs stirring slightly It is to avoid splashing during water filling. It is the water remained in the machine during the ex-factory performance inspection. It is to soak the laundries more completely.