Haier HWM80-68B User Manual - Page 7

Install the lint filter After opening the package, please take out the lint filter from the document bag, install it to the filter cover of inner tub. See to the figure. Inner tub Lint filter How to change the direction of the drain hose 1.Dismount the back cover of the washing machine. 4.Dismount the protecting cover of the drain outlet at the 2.Lay down the washing machine gently with the front other side as indicated in Figure 3. side facing the ground. Use cross screwdriver to 5.Extend the drain hose out of the other side. Fix the drain loosen the eight screws. Take off the bottomplate. hose onto the cabinet with the drain hose rack. Set the back bottom plate drain hose nut on, and fasten the nut to the direction indicated in the figure, as per Figure 4. front soft item drain outlet protecting cover fasten 3.Put down the outer drain hose. Twist the drain hose nut counterclockwise to take it off as indicated in Figure 1. Figure 3 Figure 4 Take off the drain hose rack. Put the drain hose into 6.Install the protecting cover of the drain outlet to the other the cabinet as indicated in Figure 2. side, as indicated in Figure 5. Loosen Drain hose nut Figure 1 Outer Figure 5 drain hose 7.Install the bottom plate (method the same as stated Drain hose rack drain hose nut above). Lift up the washing Figure 2 machine gently. Usage of the drain hose The drain hose shall drain smoothly 1.The height of the drain hose shall be less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way. 2.Do not ramp or press the drain hose. 4.If extra drain hose is needed, please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m. 3.If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly. If the extra hose is too long, cut it either at point A or B.