Haier HWM80-68B User Manual - Page 6

Installation and adjustment

Page 6 highlights

Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Install the bottom plate After opening the package, please lean the washing machine gently down on soft items (like towel cloth, blanket, etc.). Install the bottom plate to the bottom of the machine with eight screws by a cross screwdriver, then lift the machine up gently. See to the figure: Back Front Bottom plate Screw Soft items Adjust the installation position The largest allowable slope of the shank base of the machine is 2 . The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods: Confirm it's horizontal: If the bulb of the level meter at the balance display Air bubble position is inside the standard circle, it indicates that the machine is horizontal. Otherwise you need to adjust the adjustable leg of the machine. Suitable Not suitable Adjust the adjustable leg: Standard circle 1.To twist the adjustable leg, please first lift up the leg side slightly, loosen the adjustable nut, and then twist the leg. 2.After adjustment, fasten the nut. Loosen High Adjustable nut Fasten Low Adjustable leg

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19

Install the bottom plate
Adjust the installation position
Soft items
Bottom plate
Screw
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is
very important to your security and correct operating the machine.
Back
Front
After opening the package, please lean the
washing machine gently down on soft items
(like towel cloth, blanket, etc.). Install the
bottom plate to the bottom of the machine
with eight screws by a cross screwdriver,
then lift the machine up gently. See to the
figure:
Loosen
Fasten
High
Low
Adjustable nut
Adjustable leg
The largest allowable slope of the shank base of the machine is 2
.
The
slanting or
rough ground
will
result
in
unstable
running
or
stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:
Adjust the adjustable leg:
If the bulb of the level meter at the balance display
position is inside the standard circle, it indicates that
the machine is horizontal. Otherwise you need to
adjust the adjustable leg of the machine.
1.To twist the adjustable leg, please first lift up the
leg side slightly, loosen the adjustable nut, and
then twist the leg.
2.After adjustment, fasten the nut.
Air bubble
Standard circle
Suitable
Not suitable