Haier HWM80-68B User Manual - Page 8

Install the water inlet hose Install the water inlet pipe Water faucet, suitable water faucet, not suitable It is required that the front end shall be longer than 10mm. The outlet end surface of the faucet shall be flat and smooth. If not, please file it smooth to avoid leakage. Connection between the water inlet hose jointer and the water faucet 1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1. 2. Loosen the four screws of the water inlet hose jointer till the water faucet can be accessed. Then set the water inlet hose jointer on the faucet. See to Figure 2. If the faucet is too large and the jointer cannot be set on, please loosen the four screws and take out the bush inside the jointer. See to Figure 3. Water inlet hose jointer Slider Screw Lock level Screw knife Nameplate Bushing Water inlet hose Figure 1 Figure 2 Figure 3 3. Fasten the four screws of the water inlet hose jointer evenly. See to Figure 4. 4. Take off the nameplate. Twist the fastening nut as per the indication of the figure to seal up the exit end face of the faucet. See to Figure 5. Remark: .Before installation, the threading is 4mm above the upper surface of the nut. After installation, the threading is 2mm above the upper surface of the nut.. About 4mm after twisting About above 2mm after twisting Figure 4 Screw nut Figure 5 Figure 6 Connection between the water inlet hose and the washing machine 1 Do not takeoff the waterabsorption cushion. Pleasecheck if the cushion isdropped or damaged eachtime before using. If it happens so,please duly contact ourafter-sale service department. 2 Set the nutof the water inlethose on the waterinlet valve jointer. 3 Fasten the nut.Swing it gently toconfirm if it's fastenedwell. Water inlet hose nut Water inlet valvejointer Water absorption cushion.