Harman Kardon ADAPT PLUS Owners Manual Multilingual - Page 21
WPS-PIN, Wireless 5.1 Surround Setup
![]() |
View all Harman Kardon ADAPT PLUS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
SPEAKER SETUP WPS-PIN To connect your speaker via WPS-PIN mode: 1. Use a web browser to navigate to your Wi-Fi router or access point's setup page. 2. Press the WPS button on the bottom of your Omni Bar+ or Omni Adapt+ for 5 seconds. 3. Enter 87654325 into the WPS-PIN section of your router or access point's setup page. 4. The Link button on the top of the speaker will begin to quickly flash for up to one minute. When the LED stops flashing and turns solid white, your speaker is connected. Note: This will connect your speaker to the network. After this is complete, you must open the Harman Kardon Controller app and set up a new room for this speaker. Wireless 5.1 Surround Setup Important: When setting up a wireless 5.1 system, you must connect all speakers to a 5GHz Wi-Fi network. When setting up a surround sound system, speaker placement is important. You should place the surround speakers to the sides or behind the main seating area. Angle each speaker so it directly faces the listener. Place the speakers at the same height, preferably at about the same height as the listener's ears. After placing the speakers and connecting them to Wi-Fi (see Connecting Your Speaker to Wi-Fi on page 18), the Controller app will guide you through assigning the channels. In the bottom of the screen, you will see every available speaker on the network. Drag one of the speakers to the area for the correct position, and you will see the LED on top of that speaker flash white and hear an audio tone to identify which speaker you've selected. Make sure this is the correct speaker then repeat for each channel. Con gure speakers Drag and drop speaker here Ls Drag and drop speaker here Rs Tap the speaker below to identify it, then drag it to the correct channel Available speakers You may also upgrade any existing Omni Bar+ or Omni Adapt+ room to a wireless 5.1 system. Go to Settings > Room management and select the room you wish to add additional speakers in. Select Set up multichannel and you will be guided through the same setup process as above, with the ability to assign any other speaker already on the network to this room. Room Management Select a room to con gure: Living Room 5.1 surround Study Single product After this step is complete, continue to Source Setup on page 22. Omni 10+ Omni 10+ I can't find the correct product. 21
![](/manual_guide/products/harman-kardon-adapt-plus-owners-manual-multilingual-243b159/21.png)