Harman Kardon AVR80 Owners Manual - Page 33

AVR80 manual 11/01/98 13:01 Side 27 On Screen Display 27 ENGLISH The following functions of the AVR80 may be controlled through the Menu Control System: INPUT SELECTION: After reaching the INPUT SELECTOR menu (Figure #13), use the arrow keys on the remote q to select the desired input. Remember that when a split listening session is desired, select the VIDEO source first, followed by the AUDIO source. To use the Tape Monitor, press the down arrow button ¤ q to move the on-screen cursor. Use the ‹ and › arrow buttons to turn the Tape Monitor On or Off. RECORD OUT SELECTION: After reaching the REC OUT SELECTOR menu (Figure #14) use the navigational arrow keys to select the record source for either TAPE 1 or VCR 1. Note that if the current main input SOURCE is chosen, two more lines will appear on the screen to remind you which audio and video sources are selected (Figure #15). The RECORD OUT SELECTION effects the same as the 'Copy' Pushbuttons  Ò on the front panel. SURROUND MODE: After reaching the SURROUND MODE menu (Figure #16), use the navigational arrows q to select the desired mode. When a mode is selected that uses the surround channels, you may change the rear channel DELAY TIME at this menu. TEST TONE: At this menu you may adjust the speaker output levels. For information on this procedure, refer to the System Configuration section of this Manual, page 18. MULTI-ROOM SEL: For information on configuring and using the multiroom audio functions of the AVR80, consult the appropriate section of this Manual, page 32. SET UP MENU: For information on using the Set Up menus, refer to the System Configuration section of this Manual. REC OUT SELECTOR >TAPE *SOURCE* VCR1 *SOURCE* AUDIO *TUNER* VIDEO *LD* RETURN TO MAIN MENU Figure 15 SURROUND MODE >MODE :THX CINEMA DELAY TIME :20ms RETURN TO MAIN MENU Figure 16