Hayward SharkVAC XL Model: SharkVac XL - Page 15

Out Of Water Sensor

Get Hayward SharkVAC XL PDF manuals and user guides View all Hayward SharkVAC XL manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

OUT OF WATER SENSOR To better protect the cleaner from damage, it will sense when being asked to turn on when not safely in water, or leaves the water during operation. Out of water at start up Out of water at start up means that the cleaner has been powered on, either by the user connecting the power supply to the protected outlet and switching it on or by being connected to a timer that switches on the power supply, before the cleaner has been placed in the water. If the cleaner senses that it is not in the water the unit will power itself down. To reset the cycle, switch off the power supply for 10 seconds and restart. Out of water during operation Out of water during operation refers to the cleaner leaving or being removed from the water while in normal operation cycle. If the cleaner senses that it is no longer in the water, the unit will attempt to re-enter the water by reversing its current direction. If the cleaner is not submerged within ninety (90) seconds of leaving the water the unit will power itself down. To reset the cycle, switch off the power supply for 10 seconds and restart. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
15
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
OUT OF WATER SENSOR
To better protect the cleaner from damage, it will sense when being asked to turn on when not safely in
water, or leaves the water during operation.
Out of water at start up
Out of water at start up means that the cleaner has been powered on, either by the user connecting the
power supply to the protected outlet and switching it on or by being connected to a timer that switches on
the power supply, before the cleaner has been placed in the water. If the cleaner senses that it is not in the
water the unit will power itself down. To reset the cycle, switch off the power supply for 10 seconds and
restart.
Out of water during operation
Out of water during operation refers to the cleaner leaving or being removed from the water while in
normal operation cycle. If the cleaner senses that it is no longer in the water, the unit will attempt to
re-enter the water by reversing its current direction. If the cleaner is not submerged within ninety (90)
seconds of leaving the water the unit will power itself down. To reset the cycle, switch off the power supply
for 10 seconds and restart.