HealthRider Rc270 Bike English Manual - Page 8

9. Pull the seat knob and slide the Seat Carriage (11) 9 onto the Seat Rail (7). Refer to the inset drawing. Hold the Bumper Axle (82) inside of the Seat Rail (7). Attach a Bumper (84) to each end of the Bumper Axle with an M6 x 16mm Button Screw (85) and an M6 Washer (25) as shown. Press the Seat Rail Endcap (23) into the end of the Seat Rail. 85 7 25 84 25 23 82 84 85 7 10. Firmly tighten the four M8 x 31mm Button Screws (80) in the Seat Carriage (11). Pull the seat knob and slide the Seat Carriage (11) to the desired position. Release the seat knob and slide the Seat Carriage back and forth slightly until it locks into position. 11 Knob 10 11 11. Identify the Right Pedal (37), which is marked with 11 an "R." Using an adjustable wrench, tighten the Right Pedal clockwise into the Right Crank Arm (65). Next, tighten the Left Pedal counterclockwise into the Left Crank Arm (not shown). Firmly tighten both Pedals. Note: For the best performance, the Pedals should be regularly checked and tightened. Adjust the Right Pedal Strap (38) to the desired position, and press the Pedal Strap onto the tab on the Right Pedal (37). Adjust the Left Pedal Strap (not shown) in the same way. 80 Knob 65 38 37 Tab 12. Make sure that all parts are properly tightened before you use the exercise cycle. Place a mat beneath the exercise cycle to protect the floor. 8