HealthRider Rc270 Bike English Manual - Page 9
Adjustment And Operation
View all HealthRider Rc270 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR If you purchase the optional chest pulse sensor (refer to page 18), follow the steps below to install the receiver and the jumper wire included with the chest pulse sensor. Note: The included long jumper wire is not needed. 1. Remove the four indicated screws from the back of the Console (9). Lift off the front of the Console. 1 9 Screws Lift Here 2. Peel the paper off the adhesive pad on the back of the receiver (A). Orient the receiver exactly as shown, and 2 press it onto the Console (9) in the indicated location. Connect the short jumper wire (B) to the wire on the 9 receiver (A). Plug the other end of the short jumper wire into the indicated jack on the Console (9). Refer to step 1 above. Reattach the front of the Console (9) with the four screws. Make sure that no wires are pinched. A Cylinder Jack B ADJUSTMENT AND OPERATION HOW TO ADJUST THE POSITION OF THE SEAT For effective exercise, the seat should be in the proper position. As you pedal, there should be a slight bend in your knees when the pedals are in the farthest position. To adjust the seat, pull the seat knob and slide the seat car- riage to the Seat desired posi- Carriage tion. Release the seat knob and slide the seat carriage Seat Knob back and forth slightly until it locks into position. HOW TO ADJUST THE PEDAL STRAPS To adjust the pedal straps, first pull the ends of the straps off the tabs on the pedals. Adjust the straps to the desired positions, and then press the straps back onto the tabs. Strap Tab 9