HealthRider Stride Trainer 900 Elliptical English Manual - Page 12

14. See the upper drawing. Apply a small amount of grease to the axle on the Right Upper Body Leg (60) and to the axle on the Right Pedal Arm (58). Orient the Right Pedal Arm (58) as shown. Slide the Right Pedal Arm onto the Right Upper Body Leg (60) and into the right Roller Arm (45) at the same time. Attach the Right Pedal Arm (58) to the Right Upper Body Leg (60) with an M8 x 19mm Patch Screw (82), an Axle Cover (53), and an M8 x 25mm Washer (98); to avoid breaking the Axle Cover, do not overtighten the Patch Screw. See the lower drawing. Attach the right Roller Arm (45) to the Right Pedal Arm (58) with an M10 x 20mm Patch Screw (66) and an M10 x 25mm Washer (36). Attach the Left Pedal Arm (44) to the Left Upper Body Leg (not shown) and the left Roller Arm (45) in the same way. See step 4. Tighten the four M8 x 19mm Patch Screws (82). 14 45 Grease 60 Grease 98 53 82 58 45 44 45 66 36 58 15. Orient the Ramp Cover (10) as shown. 15 Align the mounts on the Ramp Cover (10) with the holes in the Ramp (3). Then, press the 10 Ramp Cover (10) into the Ramp. 16. Make sure that all parts are properly tight- ened before you use the elliptical. Note: After assembly is completed, some extra parts may 3 be left over. Place a mat beneath the elliptical to protect the floor. 12