HP 3500 Service Manual - Page 347
Reload Tray X - color laserjet printer cartridges
View all HP 3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 347 highlights
Table 7-2. Alphabetical printer messages (continued) Message Description Action Ready Diagnostics mode alternates with To exit press STOP key The printer is online and ready for data. No status or device attendance messages are pending at the display. No action necessary. Ready The printer is online and ready for data. No status or device attendance messages are pending at the display. No action necessary. Receiving upgrade A firmware upgrade is in progress. Do not turn the printer off until the printer returns to Ready. RELOAD TRAY X TRNSPRNCY alternates with Verify transparency meets specification The transparency currently loaded might not be supported. CAUTION Use only transparencies specified for use with HP Color LaserJet printers. Noncompatible transparencies can damage the printer. See the HP LaserJet Printer Family Print Media Specification Guide 1. Remove all non-compatible transparencies from Tray 1. 2. Load compatible transparencies in Tray 1. REPLACE CARTRIDGE alternates with For help press The identified print cartridge has reached the end of life. Printing will not continue until the cartridge is replaced. Press for help. or See Transfer unit removal (in chapter 6) and Ordering parts (in chapter 8) for more information. Or, if the cartridge is new: 1. Replace the memory controller PCB 2. Replace the DC controller PCB. REPLACE CARTRIDGE alternates with To continue press The identified print cartridge is nearing the end of its useful life and the SUPPLIES LOW setting in SYSTEM SETUP is set to STOP. To override, press . Or, if the cartridge is new, the new cartridge is defective, the memory controller PCB or the DC controller PCB is defective. 1. Order the identified print cartridge. 2. Press to continue. or Press for help. See Ordering parts (in chapter 8) for more information. REPLACE FUSER KIT For help press The fuser kit is at end of life. Press for help. or See Fuser removal (in chapter 6) and Ordering parts (in chapter 8) for more information. ENWW Printer error troubleshooting 323