HP 3500 Service Manual - Page 374
Storage Write Fail, X Storage Error
View all HP 3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 374 highlights
Table 7-3. Numerical printer messages (continued) Message Description 62 NO SYSTEM No system was found. 64 PRINTER ERROR For help press alternates with To continue turn off then on 68.X PERMANENT STORAGE FULL alternates with To continue press 68.X PERMANENT STORAGE WRITE FAIL alternates with To continue press 68.X STORAGE ERROR SETTINGS CHANGED alternates with To continue press 79.XXXX PRINTER ERROR alternates with To continue turn off then on Scan buffer error. A non-volatile storage device is full. Press to clear the message. Printing can continue, but there could be unexpected behavior. X Description: 0 - for onboard NVRAM 1 - for removable flash disk A non-volatile storage device is failing to write. Press to clear the message. Printing can continue, but there could be unexpected behavior. X Description: 0 - for onboard NVRAM. 1 - for removable flash disk. One or more printer settings saved in the non-volatile storage device is invalid and has been reset to its factory default. Press to clear the message. Printing can continue, but there could be unexpected behavior. X Description: 0 - for onboard NVRAM. 1 - for removable flash disk. HP Color LaserJet 3700 series printer only. A critical hardware error has occurred. Action 1. Turn the printer off and then back on. 2. HP 3700 only - reseat the firmware DIMM. Make sure it is in slot 1 (the bottom slot). 3. Download new firmware (HP 3700 - try downloading through the parallel port). 4. Replace the firmware DIMM. 1. Turn the printer off and then back on. 2. Perform a cold reset. 3. HP 3700 only - replace the firmware DIMM. 4. Replace the formatter PCB. 1. Press to continue. 2. For the following errors, perform the indicated action. 68.0 - turn the printer off and then back on. If the error persists, execute an NVRAM initialization. 68.1 - use the HP Web Jetadmin software to delete files from the flash disk. press to continue. For the following errors, perform the indicated action. 68.0 - turn the printer off and then back on. If the error persists, execute an NVRAM initialization. 68.1 - use the HP Web Jetadmin software to delete files from the flash disk. 1. Press to continue. 2. Turn the printer off and then back on. 3. Check the printer settings to determine which settings have been changed. 1. Turn the printer off and then back on. 2. Reseat the firmware DIMM. 3. Reseat the formatter PCB. 4. Replace the firmware DIMM. 5. Replace the formatter PCB. 350 Chapter 7 Troubleshooting ENWW