HP 4050 HP LaserJet 4050, 4050N, 4050T and 4050TN Printers - User's Guide - Page 135
Nvram Full, Check Settings, Printer Error, Cycle Power To, Continue, 8x.yyyy
UPC - 088698192764
View all HP 4050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
Printer Messages (Continued) Message 68 NVRAM FULL CHECK SETTINGS 69.x PRINTER ERROR alternates with CYCLE POWER TO CONTINUE 79.xxxx PRINTER ERROR 8x.yyyy Explanation or Recommended Action The printer's nonvolatile memory (NVRAM) is full. Some settings might have been reset to the factory defaults. Print a configuration page and check the printer settings to determine which values have changed (page 134). Hold down [Cancel Job] while turning the printer on. This will clean up the NVRAM by removing old areas that are not being used. If this message persists, contact an HP-authorized service or support provider. (See the HP Customer Care Service and Support pages at the front of this user's guide.) A temporary printing error occurred. Turn the printer off, and then turn the printer on. If this message persists, contact an HP-authorized service or support provider. (See the HP Customer Care Service and Support pages at the front of this user's guide.) The printer detected an error. The numbers (xxxx) indicate the specific type of error. Turn the printer off, and then turn the printer on. Try printing a job from a different software application. If the job prints, go back to the first application and try printing a different file. (If the message only appears with a certain software application or print job, contact the software vendor for assistance.) If the message persists with different software applications and print jobs, record the numbers that appear (xxxx) and contact an HP-authorized service or support provider. (See the HP Customer Care Service and Support pages at the front of this user's guide.) The EIO accessory in slot x has encountered a critical error as specified by yyyy. X Description 1 EIO slot 1 - The printer detected an error with the EIO accessory. 2 EIO slot 2 - The printer detected an error with the EIO accessory. 6 EIO slot 1 - The EIO accessory detected an error. The EIO accessory may be defective. 7 EIO slot 2 - The EIO accessory detected an error. The EIO accessory may be defective. Turn the printer off, and then turn the printer on. Reseat the EIO accessory. If the error persists, contact an HP-authorized service or support provider or replace the EIO accessory. EN Chapter 4: Problem Solving 113