HP 4300tn HP Jetdirect Print Servers - Administrator Guide - Page 215
HP Jetdirect Configuration Message, Description
View all HP 4300tn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
Table 9.3 802.11b Wireless Settings (3 of 3) Message Channel Authentication Type Encryption Type Description Specifies the radio frequency channel that the print server sensed and configured for communication on the network. Because it was automatically sensed from the network, this channel may differ from the user-configured channel (which is only used for broadcasts if the specified network/SSID is not found). Channel number values 1 through14 may be displayed. The allowed channels are country/region-dependent. Identifies the authentication method configured on the Jetdirect print server. It must match the method used on the network to which the print server will connect. Open System: Positive validation of a device's identification is not required for network access unless the network requires EAP authentication. An authentication failure may indicate that an EAP authentication server has rejected network access. Shared Key: Each device on the network must be configured with a shared secret WEP key to gain access to the network. Authentication failures for the Jetdirect print server may arise if the installed key is faulty, or the wrong key is active (when multiple keys are configured and stored on the print server). EAP: (Infrastructure mode only) IEEE 802.1x Extensible Authentication Protocol (EAP) uses network authentication servers for client access. HP Jetdirect EAP support includes LEAP, PEAP, EAP-MD5, EAP-TLS, and EAP-TTLS authentication protocols. An authentication failure may indicate that the EAP authentication server has rejected the print server's authentication requests. PSK: When an authentication server is not available on a network, Extensible Authentication Protocol (EAP) is used for authentication through a Pre-shared key. The Pre-shared key is generated by the print server through a user-specified network pass-phrase configured on the print server. Specifies the level of encryption configured on the Jetdirect print server. 64-bit WEP: A user-specified static 40/64-bit WEP encryption key has been configured using 5 alphanumeric ASCII characters or 10 hexadecimal digits. 128-bit WEP: A user-specified static 104/128-bit WEP encryption key has been configured using 13 alphanumeric ASCII characters or 26 hexadecimal digits. Dynamic (WEP/WPA): Dynamic encryption is being used with WEP, WPA, or both. None: Encryption keys have not been configured. ENWW HP Jetdirect Configuration Page 215