HP 4300tn HP Jetdirect Print Servers - Administrator Guide - Page 233
Table 9.12, Error Messages 2 of 11, HP Jetdirect Configuration
View all HP 4300tn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
Table 9.12 Error Messages (2 of 11) Error Code and Message Description 09 LAN ERROR BABBLE Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, replace the HP Jetdirect print server. For replacement instructions, see the hardware installation guide for your print server. 09 SCANNING FOR SSID (802.11b Wireless) The print server is scanning on all channels for devices on the specified SSID (network name). Check your specified SSID, or check status of the Access Point (Infrastructure mode) or other wireless devices. The print server will continue to scan for the specified SSID. 0A LAN ERROR NO SQE (Wired Ethernet) Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, replace the HP Jetdirect print server. 0A LAN ERROR OPEN (Token Ring) The HP Jetdirect print server could not insert into the ring and join the network. Check the data rate switch on the HP Jetdirect print server to make sure it is set correctly. For information on setting the data rate switch, see the HP Jetdirect internal print server hardware installation guides. In addition, check the cabling, external transceiver, wiring concentrator, and taps. 0C LAN ERROR RECEIVER OFF There may be a problem with your network cabling or the HP Jetdirect print server. Check the cabling and connectors on your Ethernet network. If you cannot find a problem with your network cabling, run the power-on self-test: turn the printer off, then on again. If the error persists after the printer is turned on again, there is a problem with the HP Jetdirect print server. 0D LAN ERROR TRANSMITTER OFF There may be a problem with your network cabling or the HP Jetdirect print server. Check the cabling and connectors on your Ethernet network. If you cannot find a problem with your network cabling, run the power-on self-test: turn the printer off, then on again. If the error persists, there is a problem with the HP Jetdirect print server. 0E LAN ERROR LOSS OF CARRIER Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, replace the HP Jetdirect print server. 0F LAN ERROR - WIRE FAULT (Token Ring) The HP Jetdirect print server has detected an open or short circuit in the cable between the HP Jetdirect print server and the Token Ring wiring concentrator. Verify that this cable is functional and replace it if necessary. ENWW HP Jetdirect Configuration Page 233