HP 4300tn HP Jetdirect Print Servers - Administrator Guide - Page 93
Table 3.4, Telnet Commands and Parameters 13 of 18, TCP/IP Configuration 93
View all HP 4300tn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Table 3.4 Telnet Commands and Parameters (13 of 18) DHCP Rebind Time (Read-only parameter) DHCP T2 timeout, specifying the DHCP lease rebind time (seconds). SNMP Main Settings Command Description snmp-config Enables or disables SNMP operation on the print server. 0 disables, 1 (default) enables SNMP. CAUTION: Disabling SNMP will disable all SNMP agents (SNMP v1, v2, v3) as well as communications with management applications, such as HP Web Jetadmin. In addition, firmware upgrades through current HP downloading utilities will be disabled. get-cmnty-name Specifies a password that determines which SNMP GetRequests the HP Jetdirect print server will respond to. This is optional. If a user-specified get community name is set, the print server will respond to either a user-specified community name or the factory-default. The community name must be ASCII characters. The maximum length is 255 characters. set-cmnty-name Specifies a password that determines which SNMP SetRequests (control functions) the HP Jetdirect print server will respond to. The community name of an incoming SNMP SetRequest must match the print server's "set community name" for the print server to respond. (For additional security, you may limit configuration access through the print server's host access list.) Community names must be ASCII characters. The maximum length is 255 characters. default-get-cmnty Enables or disables the default Get community name. 0 disables, 1 (default) enables. Disabling this parameter may prohibit communications with SNMP management applications. SNMP Traps Command Description auth-trap Configures the print server to send (on) or not send (off) SNMP authentication traps. Authentication traps indicate that an SNMP request was received, but the community name check failed. 0 is off, 1 (default) is on. ENWW TCP/IP Configuration 93