HP 4650dn HP Color LaserJet 4650 series printer - User Guide - Page 190
Unable to Store Job, TRAY XX=[TYPE]
UPC - 829160106267
View all HP 4650dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 190 highlights
Control panel messages (continued) Control panel message Description Recommended action TRAY XX SIZE= Verify tray switch set to CUSTOM alternates with TRAY XX SIZE= then close tray A non-detectable media size was selected from the menu and the tray is open. The selected size requires that the tray switch be set to CUSTOM, otherwise when the tray is closed, the tray size will change. 1. Adjust the side and rear media guides against the paper. 2. If the media used is letter, A4, executive, JIS B5, A5, or legal, the tray switch should be set to STANDARD. Set the tray switch to CUSTOM for all other media sizes. The tray switch must be set before the size can be selected from the control panel. 3. Close the tray. TYPE MISMATCH TRAY XX=[TYPE] For help press alternates with Ready The media type loaded in the tray does not match the media type configured for the tray. 1. Adjust the side and rear guides against the paper. 2. If size is a detectable size, set the tray switch to STANDARD, otherwise set the tray switch to CUSTOM. 3. If necessary, press after the tray is closed to change the paper size or type. Unable to mopy job alternates with Processing... A Mopy job cannot be mopied because Install additional memory in the printer or of a memory, disk, or configuration install a disk drive in the printer. problem. Only one copy will be produced. Unable to Store Job alternates with Processing... A job cannot be stored because of a memory, disk, or configuration problem. Install additional memory in the printer, or install a disk drive into the printer. If a disk drive is installed, delete previously stored print jobs. USE TRAY XX [TYPE] [SIZE] To change press / To use press The printer is offering a selection of alternate media to use for the print job. 1. View tray configurations (type and size) using and . 2. Press to select a tray to use. Wait for printer to reinitialize RAM disk settings have been changed before the printer automatically restarts, or external device modes have changed or the printer is coming out of the diagnostics mode and will automatically restart. No action necessary. Warming up The printer is coming out of PowerSave mode. Printing will continue as soon as warmup is completed. No action necessary. 176 Chapter 8 Problem solving ENWW