HP 6120G/XG HP ProCurve Series 6120 Blade Switches Installation and Getting St - Page 41

Restoring the Factory Default Configuration Restoring Factory Firmware This feature is built into the boot ROM, and it provides a way to recover from a situation where both primary and secondary images are not bootable. Since the xmodem download will not work on the 6120XG or the 6120G/XG switch, this is the mechanism to use in case both images are not bootable. Required user action is highlighted. ROM information: Build directory: /sw/rom/build/vernrom(titan4_v14_release) Build date: July 9 2009 Build time: 10:54:18 Build version: Z.14.03 Build number: 25751 Boot Profiles: 0. Monitor ROM Console 1. Primary Software Image 2. Secondary Software Image Select profile (secondary):0 516733-B21:HP ProCurve 6120XG Blade Switch ROM Build Directory: /sw/rom/build/vernrom(titan4_v14_release) ROM Version: Z.14.03 ROM Build Date: 10:54:18 Jul 9 2009 ROM Build Number: 25751 Copyright (c) 1995-2008 Hewlett-Packard Company. All rights reserved. RESTRICTED RIGHTS LEGEND Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subdivision (b) (3) (ii) of the Rights in Technical Data and Computer Software clause at 52.227-7013. Hewlett-Packard Company, 3000 Hanover Street, Palo Alto, CA 94303 Enter h or ? for help. =>recover * * * You've invoked the Product Recovery command. * * * * Product Recovery is intended for use when neither the Primary nor the * * Secondary product images are bootable. * * * * If you continue, this command will do the following: * * 1. Overwrite Primary with the original factory released image. * * 2. Clear configuration and boot the new Primary product code. * * * * The recovery process will take about 4 minutes to complete, please do * * not reset or power off the system during recovery. If you do not wish * * to perform Recovery at this time, enter 'C' at the prompt to Cancel. * * * Please confirm! Enter 'P' to Proceed, or 'C' to Cancel: p 33