HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Comma - Page 345
Routing policy configuration commands, apply as-path, apply comm-list delete
![]() |
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 345 highlights
Routing policy configuration commands The common routing policy configuration commands are applicable to both IPv4 and IPv6. Common routing policy configuration commands apply as-path Syntax apply as-path as-number& [ replace ] View undo apply as-path Routing policy view Default level 2: System level Parameters as-number&: AS number, in the range of 1 to 4294967295. &: Indicates you can enter up to 10 AS numbers. replace: Replaces the original AS numbers. Description Use apply as-path to apply the specified AS numbers to BGP routes. Use undo apply as-path to remove the clause configuration. No AS_PATH attribute is set by default. With the replace keyword included, the apply as-path command replaces the original AS_PATH attribute with the specified AS numbers. Without the replace keyword, this command adds the specified AS numbers before the original AS_PATH attribute. Examples # Configure node 10 in permit mode of routing policy policy1: add AS number 200 before the original AS_PATH attribute of BGP routing information matching AS path list 1. system-view [Sysname] route-policy policy1 permit node 10 [Sysname-route-policy] if-match as-path 1 [Sysname-route-policy] apply as-path 200 apply comm-list delete Syntax apply comm-list { comm-list-number | comm-list-name } delete undo apply comm-list 334
![](/manual_guide/products/hewlettpackard-6125g-hp-6125g-amp-6125gxg-blade-switches-layer-3-ip-routing-command-referencer2103-72a133c/345.png)