HP Brocade 8/12c Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01 - Page 559

Adding encryption targets 18 The list of engines depends on the scope being viewed. • If the Targets dialog box is showing all targets in an encryption group, the list includes all engines in the group. • If the Targets dialog box is showing all targets for a switch, the list includes all encryption engines for the switch. • If the Targets dialog box is showing targets for a single encryption engine, the list contains only that engine. 5. Select the encryption engine (blade or switch) to configure, then click Next. The Select Target dialog box displays (Figure 225). The dialog box lists all target ports and target nodes in the same fabric as the encryption engine. The Targets in Fabric table does not show targets that are already configured in an encryption group. You can select targets from the list of known targets, or manually enter the port and node WWNs. FIGURE 225 Select Target dialog box a. Select a target from the list. (The Target Port WWN and Target Node WWN fields contain all target information that displays when using the nsshow command.) You can also enter WWNs manually, for example, to specify a target that is not on the list. b. Select a target type from the Type list. If the target node is disk storage, choose Disk. If the target node is tape storage, choose Tape. 6. Click Next. The Select Hosts dialog box displays (Figure 226). The dialog box lists all hosts that are in the same fabric as the encryption engine. Brocade Network Advisor SAN User Manual 515 53-1002167-01