HP Brocade 8/12c Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01 - Page 693

Adding an FCIP circuit 20 Adding an FCIP circuit When adding a new FCIP tunnel, you can add an FCIP circuit by selecting the Add button to the right of the Circuits properties table on the Add FCIP Tunnel dialog box (Figure 288 on page 648). For 8 Gbps platforms, you can add multiple FCIP circuits to the tunnel with this button. Add circuits to existing FCIP tunnels through the Edit FCIP Tunnel dialog box. To display this dialog box, right-click a tunnel on the FCIP Tunnels dialog box and select Edit Tunnel or select a tunnel and click the Edit button. For details, refer to "Editing FCIP tunnels" on page 662. FIGURE 289 Add FCIP Circuit dialog box 1. Select the GiGE Port used for the Ethernet connection on each switch. The choices available depend on the extension switch or blade model. 2. Select Use as failover to configure the 10 GbE port on an 8 Gbps Blade platform as a 10 Gbps lossless failover circuit. 3. Select the IP Address Type. The implementation is a dual IP layer operation implementation as described in RFC 4213. IPv6 addresses can exist with IPv4 addresses on the same interface, but the FCIP circuits must be configured as IPv6 to IPv6 and IPv4 to IPv4 connections. IPv6-to-IPv4 connections are not supported. Likewise, encapsulation of IPv4 in IPv6 and IPv6 in IPv4 is not supported. Document Title 649 xx-xxxxxxx-01