HP C5180 Basics Guide - Page 28
Network troubleshooting, Set Country/Region, Cause, Solution, Preferences, Contact HP, Basics Guide - reset
UPC - 882780529755
View all HP C5180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Troubleshooting and support 6. Press to highlight Set Country/Region, and then press OK. 7. Press to scroll through the countries/regions. When the country/region you want to use appears, press OK. 8. When prompted, press to highlight Yes or No, and then press OK. The wrong measurements are showing in menus on the display Cause You might have selected the incorrect country/region when setting up the HP All-inOne. The country/region you select determines the paper sizes shown on the display. Solution To change the country/region, you must reset the language settings. You can change the language settings at any time from the Preferences menu. I received a message on the display that the printer alignment failed Cause The incorrect type of paper is loaded in the input tray (for example, colored paper, paper with text on it or, certain recycled paper). Solution Load unused plain white letter or A4 paper into the input tray, and then try the alignment again. If the alignment fails again, you might have a defective sensor on the print head assembly. Contact HP Support. Go to www.hp.com/support. If prompted, choose your country/region, and then click Contact HP for information on calling for technical support. I received a message on the display about a paper jam or a blocked print head assembly Solution If either a paper jam or blocked print head assembly error message appears on the display, there might be some packing material inside the HP All-in-One. Open the ink cartridge door, and check for obstructions in the device. Remove any packing materials or other obstructions. The HP All-in-One does not print Cause The HP All-in-One and computer are not communicating with each other. Solution Check the connection between the HP All-in-One and computer. Cause There might be a problem with one or more of the ink cartridges. Solution Check that the ink cartridges are installed properly and have ink. Cause The HP All-in-One might not be turned on. Solution Look at the display on the HP All-in-One. If the display is blank and the On button is not lit, the HP All-in-One is turned off. Make sure the power cord is firmly connected to the HP All-in-One and plugged into a power outlet. Press the On button to turn on the HP All-inOne. Cause The HP All-in-One might be out of paper. Solution Load paper in the input tray. Network troubleshooting This section contains network troubleshooting information for the HP All-in-One. Specific information is provided for installation and configuration issues. ● The computer is unable to discover the HP All-in-One ● I received a System Requirements Error: No TCP/IP ● The Printer not Found screen appears during installation ● I am using a cable modem without a router and I do not have IP addresses Basics Guide 25