HP CP3525dn Service Manual - Page 399
Table 7-13, Control-panel messages continued - weight of color laserjet
UPC - 883585891948
View all HP CP3525dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 399 highlights
Table 7-13 Control-panel messages (continued) Control panel message Description Recommended action release. If it drops back down without hesitation, it is operating correctly. 13.02.00 JAM IN RIGHT DOOR The product fed a sheet of paper from one of the trays and it reached the TOP sensor, but stayed there too long. This jam is commonly caused by multiple sheets being fed into the paper path at one time. Printing glossy media in a humid environment can cause this jam. 13.04.00 JAM IN RIGHT DOOR The product fed a sheet of paper from one of the trays, and it made it to the PF media feed sensor, but the paper stayed there too long. This jam is commonly caused by multiple sheets being fed into the paper path at one time. Printing glossy media in a humid environment can cause this jam. 13.05.00 FUSER AREA JAM The product fed a sheet of paper from one of 1. the trays, and it made it to the TOP Sensor, but did not reach the fuser delivery sensor in time. Check the paper path for damage. This is a delay jam. Although the paper stopped at or in the fuser, the root cause is more likely a paper feed/pick-up issue. 13.06.00 FUSER AREA JAM 2. Check the fuser for damage to the pressure-roll cover. The product fed a sheet of paper from one of 1. the trays and it made it past the TOP sensor and to the fuser delivery sensor in time, but it stayed in the fuser too long. 2. Check for the presence of paper in the fuser. Curled sheets in the output bin might cause jams to occur, which is especially true if using light media (less than 75 g/ m2). 3. Check the fuser for damage to the pressure roll cover. 13.12.00 JAM IN RIGHT DOOR 13.13.00 JAM IN RIGHT DOOR The product fed a sheet of paper from one of 1. the trays, and it made it to the fuser delivery sensor in time, but did not make it to the duplex re-pickup sensor in time (HP Color 2. LaserJet CP3525dn printer and HP Color LaserJet CP3525x printer only). Make sure the loaded paper is not skewed. Check the media weight to make sure it is within specification. If it is not, the customer must manually duplex. The product fed a sheet of paper from one of the trays, and it made it to the duplex repickup sensor in time, but it did not make it to the TOP sensor in time when printing the second side of a duplex print job (HP Color LaserJet CP3525dn printer and HP Color LaserJet CP3525x printer only). Check the media weight to make sure it is within specification. If it is not, the customer must manually duplex. 13.1C.00 FUSER WRAP JAM 13.20.00 JAM IN RIGHT DOOR During printing, the fuser delivery sensor detected paper wrapping around the fuser film. Inspect the fuser for damage. During a checking-printer cycle, the product 1. detected the presence of paper at the PF media-feed sensor, TOP sensor, loop sensor 1, fuser delivery sensor, and duplex re-pickup sensor. 2. Open the right door and check for the presence of paper. Remove any that is present. Check the TOP sensor, loop sensor 1, fuser delivery sensor, and duplex repickup sensor for proper operation. 3. If the paper feeder (Tray 3) is connected, open the lower-right door ENWW Control-panel messages table 371