HP Cisco MDS 9020 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 263
PLATFORM-3, show sprom module [decimaldigit], show sprom module, show platform internal all module
View all HP Cisco MDS 9020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 263 highlights
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message PLATFORM-2-PS_UNSUPPORTED: Detected an unsupported power supply [dec] [chars] for CISCO MDS 9500/9200 Multilayer Switches (Serial number [chars]). Explanation This power supply is not supported for the Cisco MDS 9500 or 9200 series of switches. Recommended Action Refer to the appropriate product hardware installation guide for information on increasing or decreasing power supply capacity and configuring power supplies. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PLATFORM-2-SYS_IDPROMBAD: Chassis IDPROM [dec] data invalid. Explanation The named chassis IDPROM contains invalid data. Recommended Action Use the show sprom module [decimaldigit] CLI command to read module IDPROM contents and collect more information. Or, use a similar Fabric Manager procedure. Introduced Cisco MDS SAN-OS Release 3.0(1). Error Message PLATFORM-2-SYS_IDPROMBAD_RECOVER_FAIL: Chassis IDPROM [dec] data re-initialization Un-successful. Data is invalid. Explanation Chassis IDPROM re-initialization was unsuccessful. The data is invalid. Recommended Action Us ethe 'show sprom module decimal digit 1 CLI command to read the module IDPROM contents and collect more information. Introduced Cisco MDS SAN-OS Release 3.0(2). Error Message PLATFORM-2-SYS_IDPROMBAD_RECOVER_PASS: Chassis IDPROM [dec] data re-initialized successfully. Explanation Chassis IDPROM invalid data was succesfully re-initialized to valid. Recommended Action Us ethe 'show sprom module decimal digit 1 CLI command to read the module IDPROM contents and verify the information. Introduced Cisco MDS SAN-OS Release 3.0(2). PLATFORM-3 Error Message PLATFORM-3-MOD_PWRFAIL: Module [dec] failed to power up (Serial No. [chars]). Explanation The module failed to power up. Recommended Action Enter the show platform internal all module [dec] CLI command or use a similar Fabric Manager/Device Manager procedure to collect more information. Introduced Cisco MDS SAN-OS Release 1.2(2a). OL-15956-01 Cisco MDS 9000 Family System Messages Reference 2-227