HP Cisco MDS 9020 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 96
show interface, ip route, traceroute, FCIP peer. Enter
View all HP Cisco MDS 9020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message ETHPORT-5-IF_DOWN_SUSPENDED_BY_MODE: Interface [chars] is down (Suspended due to incompatible mode). Explanation This interface belongs to a PortChannel and the operational mode of the interface is different from that of the PortChannel. Recommended Action Change the mode and the trunking mode of the PortChannel from auto and check to ensure that the remote end of the interface also belongs to the same PortChannel. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message ETHPORT-5-IF_DOWN_SUSPENDED_BY_SPEED: Interface [chars] is down (Suspended due to incompatible speed). Explanation This interface belongs to a PortChannel and operational mode of the interface is different from that of the PortChannel. Recommended Action Change the speed of the PortChannel from auto and check to ensure that the remote end of the interface also belongs to the same PortChannel. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message ETHPORT-5-IF_DOWN_SUSPENDED_BY_WWN: Interface [chars] is down (Suspended due to incompatible remote switch WWN). Explanation This interface belongs to a PortChannel and the remote switch WWN of the interface is different from that of the PortChannel. Recommended Action Ensure that this interface is connected to the same remote switch as all the other interfaces in the PortChannel. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message ETHPORT-5-IF_DOWN_TCP_KEEP_ALIVE_EXPIRED: Interface [chars] is down(TCP conn. closed - Keep alive expired). Explanation The TCP session to the FCIP peer was closed due to loss of the TCP keepalive. Recommended Action This may be due to loss of IP connectivity. Enter the show interface and show ip route CLI commands to provide the IP address of the peer and the route used to connect to this FCIP peer. Enter traceroute [ipaddr] to check the connectivity to the peer. You can alternatively use Fabric Manager and/or Device Manager instead of the command line method. Introduced Cisco MDS SAN-OS Release 1.2(2a). 2-60 Cisco MDS 9000 Family System Messages Reference OL-15956-01