HP Color LaserJet CM4730 Service Manual - Page 563
Output Accessory Bridge Attached
View all HP Color LaserJet CM4730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 563 highlights
Table 6-2 Control-panel messages (continued) Control panel message Description Recommended action Load Tray 1 The tray is empty or configured for a different size than the size requested. 1. If the correct paper is loaded, touch OK. 2. Otherwise, remove the incorrect paper and load tray 1 with the specified paper. 3. If prompted, confirm the size and type of paper loaded. 4. Confirm that the media guides are in the correct position. 5. To use another tray, remove paper from tray 1 and then touch OK. Manually feed The specified job requires manual feed from tray 1. Load the requested media into tray 1. To override the message, touch OK to use a type and size of media that is available in another tray. Network connection required for Digital Sending. Contact administrator. A digital-sending feature has been configured, but a network connection is not detected. Verify the network connection. See Troubleshooting network printing problems on page 615. Contact the network administrator. Non-HP supply installed A refilled color or a cloned color/mono cartridge has been installed, and the printer previously used all genuine HP supplies. It can also appear when an unauthorized cartridge has been installed and the printer previously used all genuine supplies. Install a genuine HP cartridge, or touch OK to override the condition. Novel login required Novell authentication has been enabled for Enter Novell network credentials to access this destination. the requested feature. Order Cartridge The identified print cartridge is nearing the end of its useful life. The MFP is ready and will continue for the estimated number of pages indicated. Estimated pages remaining is based upon the historical page coverage of this MFP. Order a replacement print cartridge. Printing will continue until a supply needs to be replaced. Order Fuser Kit The fuser is near end of life. The MFP is ready and will continue for the estimated number of pages indicated. Printing will continue until a supply needs to be replaced. Order a replacement fuser kit. Order staple cartridge The staple cartridge needs to be replaced. Replace the staple cartridge. Order Supplies One or more supplies needs to be replaced. Replace the supply. Order Transfer Kit The transfer kit is near end of life. Printing can continue. Order a replacement transfer kit. Output Accessory Bridge Attached The IPTU is attached. No action required. Output Accessory Bridge Disconnected The IPTU is disconnected. Verify that the IPTU connection is secure. If necessary, remove and then reinstall the IPTU. ENWW Control-panel messages 543