HP ENVY 15-k300 Maintenance and Service Guide - Page 58

The power connector cover has two screws, however, the screw on the left is removed during

Get HP ENVY 15-k300 PDF manuals and user guides View all HP ENVY 15-k300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 58 highlights

3. On the right side, disconnect the WLAN cable (3) and carefully remove the cable from the retaining tabs (4). 4. Remove the power connector cover by removing the Phillips screw (1) and lifting the cover (2). NOTE: The power connector cover has two screws, however, the screw on the left is removed during the base enclosure and top cover removal process. Removing the cover is required for the display panel removal. NOTE: You will remove the power connector after you have removed the system board. This procedure is to remove the power connector cover. 48 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
3.
On the right side, disconnect the WLAN cable
(3)
and carefully remove the cable from the retaining tabs
(4)
.
4.
Remove the power connector cover by removing the Phillips screw
(1)
and lifting the cover
(2)
.
NOTE:
The power connector cover has two screws, however, the screw on the left is removed during
the base enclosure and top cover removal process. Removing the cover is required for the display panel
removal.
NOTE:
You will remove the power connector after you have removed the system board. This
procedure is to remove the power connector cover.
48
Chapter 6
Removal and replacement procedures for Authorized Service Provider parts