HP ENVY Rove 20-k014us User Guide - Page 58

IMPORTANT, Be sure that the mouse is - battery replacement

Get HP ENVY Rove 20-k014us PDF manuals and user guides View all HP ENVY Rove 20-k014us manuals
Add to My Manuals
Save this manual to your list of manuals

Page 58 highlights

● Replace the batteries in the keyboard and mouse. ● Remove the wireless USB receiver on the bottom of the stand, and then reinsert it. Re-pair the keyboard and mouse to the receiver. NOTE: The illustrations below may look slightly different from your keyboard and mouse. IMPORTANT: During these steps, place the keyboard and mouse on the same level as the receiver. To re-pair the keyboard and mouse: 1. Disconnect the receiver from the USB port on the bottom of the computer stand, and then reconnect it. See Bottom on page 9for the location of the USB port. 2. Be sure that the mouse is on (1), and then press and hold the Connect button (2) for 5 to 10 seconds, until the LED on the receiver lights up or stops flashing. To confirm the connection, move the mouse and check for a response on the screen. 3. After the mouse connection is established, complete the following steps to re-pair the keyboard. 50 Chapter 11 Troubleshooting

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
●
Replace the batteries in the keyboard and mouse.
●
Remove the wireless USB receiver on the bottom of the stand, and then reinsert it. Re-pair the
keyboard and mouse to the receiver.
NOTE:
The illustrations below may look slightly different from your keyboard and mouse.
IMPORTANT:
During these steps, place the keyboard and mouse on the same level as the
receiver.
To re-pair the keyboard and mouse:
1.
Disconnect the receiver from the USB port on the bottom of the computer stand, and then
reconnect it. See
Bottom
on page
9
for the location of the USB port.
2.
Be sure that the mouse is on
(1)
, and then press and hold the Connect button
(2)
for 5 to 10
seconds, until the LED on the receiver lights up or stops flashing. To confirm the connection,
move the mouse and check for a response on the screen.
3.
After the mouse connection is established, complete the following steps to re-pair the keyboard.
50
Chapter 11
Troubleshooting