HP EliteDesk 800 95W G4 Maintenance and Service Guide - Page 24
Access panel
View all HP EliteDesk 800 95W G4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Access panel To access internal components, you must remove the access panel: 1. Prepare the computer for disassembly (Preparation for disassembly on page 15). 2. Remove the thumbscrew on the rear of the computer (1). Then slide the panel forward (2), and then lift it off the computer (3). NOTE: If necessary, a Torx T15 or flat-bladed screwdriver can be used to loosen the thumbscrew. NOTE: Your computer model may look slightly different from the illustration in this section. Some models have vent holes on the access panel. 16 Chapter 4 Removal and replacement procedures
Access panel
To access internal components, you must remove the access panel:
1.
Prepare the computer for disassembly (
Preparation for disassembly
on page
15
).
2.
Remove the thumbscrew on the rear of the computer
(1)
. Then slide the panel forward
(2)
, and then lift
it
off
the computer
(3)
.
NOTE:
If necessary, a Torx T15 or
flat-bladed
screwdriver can be used to loosen the thumbscrew.
NOTE:
Your computer model may look slightly
different
from the illustration in this section. Some
models have vent holes on the access panel.
16
Chapter 4
Removal and replacement procedures