HP EliteDesk 800 95W G4 Maintenance and Service Guide - Page 42
Fan, To install the fan, reverse the removal procedure.
View all HP EliteDesk 800 95W G4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Fan 1. Prepare the computer for disassembly (Preparation for disassembly on page 15). 2. Remove the access panel (Access panel on page 16). 3. Disconnect the fan cable from the system board (1). 4. Remove the fan cable from the clips on the side of the heat sink (2). 5. Lift fan up to about 30-45 degrees (3), and then pull it away from the heat sink (4). To install the fan, reverse the removal procedure. 34 Chapter 4 Removal and replacement procedures
Fan
1.
Prepare the computer for disassembly (
Preparation for disassembly
on page
15
).
2.
Remove the access panel (
Access panel
on page
16
).
3.
Disconnect the fan cable from the system board
(1)
.
4.
Remove the fan cable from the clips on the side of the heat sink
(2)
.
5.
Lift fan up to about 30-45 degrees
(3)
, and then pull it away from the heat sink
(4)
.
To install the fan, reverse the removal procedure.
34
Chapter 4
Removal and replacement procedures