HP EliteDesk 800 G4 Hardware Reference Guide - Page 27

Drive positions, Removing and installing drives

Get HP EliteDesk 800 G4 PDF manuals and user guides View all HP EliteDesk 800 G4 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

12. Replace the computer access panel. 13. If the computer was on a stand, replace the stand. 14. Reconnect the power cord and any external devices, and then turn on the computer. 15. Lock any security devices that were disengaged when the access panel was removed. 16. Reconfigure the computer, if necessary. Drive positions Table 2-2 Drive positions Drive positions 1 3.5-inch secondary hard drive bay 2 3.5-inch primary hard drive bay 3 2.5-inch hard drive bay 4 9.5 mm slim optical drive bay NOTE: The drive configuration on your computer may be different than the drive configuration shown above. Removing and installing drives When installing drives, follow these guidelines: ● The primary Serial ATA (SATA) hard drive must be connected to the dark-blue primary SATA connector on the system board labeled SATA0. ● Connect secondary hard drives and optical drives to one of the light-blue SATA connectors on the system board labeled SATA1 and SATA2. Drive positions 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
12.
Replace the computer access panel.
13.
If the computer was on a stand, replace the stand.
14.
Reconnect the power cord and any external devices, and then turn on the computer.
15.
Lock any security devices that were disengaged when the access panel was removed.
16.
Reconfigure the computer, if necessary.
Drive positions
Table 2-2
Drive positions
Drive positions
1
3.5-inch secondary hard drive bay
2
3.5-inch primary hard drive bay
3
2.5-inch hard drive bay
4
9.5 mm slim optical drive bay
NOTE:
The drive configuration on your computer may be different than the drive
configuration shown above.
Removing and installing drives
When installing drives, follow these guidelines:
●
The primary Serial ATA (SATA) hard drive must be connected to the dark-blue primary SATA connector on
the system board labeled SATA0.
●
Connect secondary hard drives and optical drives to one of the light-blue SATA connectors on the system
board labeled SATA1 and SATA2.
Drive positions
21