HP EliteDesk 800 G4 Hardware Reference Guide - Page 42
Rotate the drive cage back down to its normal position.
![]() |
View all HP EliteDesk 800 G4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
8. Connect the power cable (1) and data cable (2) to the rear of the hard drive. NOTE: If the 2.5-inch hard drive is the primary drive, connect the other end of the data cable to the dark-blue SATA connector on the system board labeled SATA0. If it is a secondary hard drive, connect the other end of the data cable to one of the light-blue SATA connectors on the system board. 9. Rotate the drive cage back down to its normal position. IMPORTANT: Be careful not to pinch any cables or wires when rotating the drive cage down. 10. Replace the front bezel. 36 Chapter 2 Hardware upgrades
![](/manual_guide/products/hewlettpackard-elitedesk-800-g4-hardware-reference-guide-9346da3/42.png)
8.
Connect the power cable (1) and data cable (2) to the rear of the hard drive.
NOTE:
If the 2.5-inch hard drive is the primary drive, connect the other end of the data cable to the
dark-blue SATA connector on the system board labeled SATA0. If it is a secondary hard drive, connect the
other end of the data cable to one of the light-blue SATA connectors on the system board.
9.
Rotate the drive cage back down to its normal position.
IMPORTANT:
Be careful not to pinch any cables or wires when rotating the drive cage down.
10.
Replace the front bezel.
36
Chapter 2
Hardware upgrades