HP Kayak XU 04xx HP Kayak XU and XW Series U3 and W3 PC Workstations - User Gu - Page 63

crystal.bk : cryst-2.fb4 Page 47 Monday, March 23, 1998 4:09 AM 2 How to Install Accessories Inside Your PC Workstation Installing Mass Storage Devices Before Installing an IDE Device Before Installing a SCSI Device Installing a Drive in a Front-Access Shelf These instructions explain how to install a drive (such as a flexible disk drive, a CD-ROM drive, CD-RW drive, or a tape drive) in one of the front-access drive shelves. You should also refer to the manual supplied with the drive for any additional installation instructions. Refer to the drive's installation guide to see if you must set jumpers or if there is a special installation procedure to follow. If you are installing a SCSI device, refer to the section "Before Installing a SCSI Hard Disk" on page 40 before using the following instructions. 1 Disconnect the computer's power cord and any telecommunications cable. 2 Remove the computer's cover (see page 25). 3 Slide out the power supply to provide better access to the disk drive cables (see page 29). 4 If installing a drive in a 5.25-inch wide shelf, remove the drive tray and put it in a safe place. Remove the drive tray if installing a 5.25-inch drive Mounting Rails Slide the drive into position 5 Slide the drive into the shelf. 6 Secure the drive in position using the screws provided with the drive. English 47