HP LH4r HP Netserver LC 2000 Pedestal-to-Rack Guide - Page 18
See
 |
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Chapter 2 Rack Mounting the HP NetServer 6. Hold a slide in position inside the two left-hand rack columns and observing the following items. a. The mounting flange on each end of the slide must wrap around the outside face of both the front and rear columns. See Figure 2-6. b. The two holes in the mounting flange should line up with the captive nuts (at 7th and 9th holes) in the column adapter and the two rack nuts you installed on each rear column. c. The extending portion of the slide (slide member) should point forward out of the rack. Mount Slides inside Column Adapters Extend rack's anti-tip foot from front of rack for safety. Figure 2-6. Securing the Slides to the Rack Columns 14
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13 -
14 -
15 -
16 -
17 -
18 -
19 -
20 -
21 -
22 -
23 -
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
 |
 |
Chapter 2
Rack Mounting the HP NetServer
14
6.
Hold a slide in position inside the two left-hand rack columns and
observing the following items.
a.
The mounting flange on each end of the slide must wrap around the
outside face of both the front and rear columns.
See Figure 2-6.
b.
The two holes in the mounting flange should line up with the captive
nuts (at 7th and 9th holes) in the column adapter and the two rack nuts
you installed on each rear column.
c.
The extending portion of the slide (slide member) should point forward
out of the rack.
Extend rack’s
anti-tip foot
from front of rack
for safety.
Mount Slides
inside Column
Adapters
Figure 2-6. Securing the Slides to the Rack Columns