HP LH4r HP Netserver LC 2000 Pedestal-to-Rack Guide - Page 25
Go to Attaching the Cable Management Arm before securing the HP
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 2 Rack Mounting the HP NetServer 11. Take the handles off the NetServer and store the handles and screws in a convenient place. See Figure 2-11. The handles can be re-attached whenever you remove the NetServer from the rack. If moving the NetServer elsewhere, always package it with the handles attached. 12. Press in the release latches on each slide, and push the NetServer all the way into the rack. See Figure 2-12. The blue Slide Release buttons in the Bezel moldings on each side of chassis' front edge must click into the latches in the column adapters on the two front rack columns. Figure 2-12. Pressing in the Release Latches 13. Verify the NetServer will slide all the way into the rack, before continuing with the procedures. 14. Go to "Attaching the Cable Management Arm" before securing the HP NetServer in the rack. 21