HP LH4r HP Netserver LC 2000 Pedestal-to-Rack Guide - Page 19

Fasten the slide's rear bracket to the rack nuts on the left-rear column.

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

Chapter 2 Rack Mounting the HP NetServer 7. With the slide pushed firmly into position, insert two screws through the slide's front bracket into the captive nuts on the left column adapter. a. Secure the screws only loosely at first, so the bracket can settle into the lowest possible position. There is a dimple in the bracket to position the slides in the proper location. b. Then tighten the screws until the bracket is held firmly to the column adapter and rack column. See Figures 2-5 and 2-6. 8. Fasten the slide's rear bracket to the rack nuts on the left-rear column. a. Secure the screws only loosely at first, so the bracket can settle into the lowest possible position. There is a dimple in the bracket to position the slides in the proper location. b. Then tighten the screws until the bracket is held firmly to the column. 9. Attach the other slide to the right-front column adapter and right-rear rack column by repeating Steps 2 through 8. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
Chapter 2
Rack Mounting the HP NetServer
15
7.
With the slide pushed firmly into position, insert two screws through the
slide’s front bracket into the captive nuts on the left column adapter.
a.
Secure the screws only loosely at first, so the bracket can settle into the
lowest possible position.
There is a dimple in the bracket to position
the slides in the proper location.
b.
Then tighten the screws until the bracket is held firmly to the column
adapter and rack column. See Figures 2-5 and 2-6.
8.
Fasten the slide’s rear bracket to the rack nuts on the left-rear column.
a.
Secure the screws only loosely at first, so the bracket can settle into the
lowest possible position. There is a dimple in the bracket to position
the slides in the proper location.
b.
Then tighten the screws until the bracket is held firmly to the column.
9.
Attach the other slide to the right-front column adapter and right-rear rack
column by repeating Steps 2 through 8.