HP LH4r HP Netserver LH 3/LH 3r Processor Upgrade Guide - Page 16
Removing the Terminator Board
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Chapter 1 Processor Module Installation Removing the Terminator Board If your system has one processor, a terminator board is installed in the upper slot. You must remove the terminator board before installing a processor module into this slot. (See Figure 1-10). 1. Squeeze together the two retaining latches on the terminator board. 2. Pull the terminator board out of the socket. Save the terminator board for future use. Terminator Board Terminator Board Retaining Latches Figure 1-10. Removing the Terminator Board 12
Chapter 1
Processor Module Installation
12
Removing the Terminator Board
If your system has one processor, a terminator board is installed in the upper slot.
You must remove the terminator board before installing a processor module into
this slot. (See Figure 1-10).
1.
Squeeze together the two retaining latches on the terminator board.
2.
Pull the terminator board out of the socket.
Save the terminator board for future use.
Terminator Board
Terminator Board
Retaining Latches
Figure 1-10. Removing the Terminator Board