HP LH4r HP Netserver LH 3/LH 3r Processor Upgrade Guide - Page 23
Setting the Processor Speed Switches
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Chapter 1 Processor Module Installation Setting the Processor Speed Switches After installing processors, verify that the processor speed switches are set correctly. If the switches are not set correctly, set them accordingly. NOTE If two processors are installed in the NetServer, both must be the same speed. To set the processor speed switches: 1. Locate the switches and the switch chart at the upper right corner of the system board (see Figure 1-9). 2. Look up the appropriate switch settings (located on the chart adjacent to the switches) for the processor module(s) installed in the NetServer. 3. Set the switches accordingly. CAUTION Processor modules are designed to operate at only one speed. This speed is printed on the module. Do not set the processor speed switches to any speed other than that speed labeled on the module. Setting the processor speed to another speed may result in unreliable or intermittent performance. Data integrity may also be placed at risk if processors are operated at speeds other than that specified on the processor module. 19