HP LH4r HP Netserver LH 3/LH 3r Processor Upgrade Guide - Page 24
Completing the Installation
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Chapter 1 Processor Module Installation Completing the Installation Complete the processor module installation by installing the system board, covers, and bezel. CAUTION Never operate this NetServer without first installing all covers and the front bezel. Operating the system without all covers in place reduces critical cooling airflow over some components, such as hard disk drives and processor modules. Operating the system without all covers in place may result in failure of these components. Separate procedures follow to complete installation for the HP NetServer LH 3 and the HP NetServer LH 3r. Completing the HP NetServer LH 3 Installation To complete the installation: CAUTION Replace all covers before operating the HP NetServer, even for a short time. Otherwise, damage to system components can result due to improper cooling flow. 1. Install cover 3 by inserting the cover tabs into slots on the chassis. Slide the cover toward the rear of the chassis and tighten the thumbscrew. 2. Install the bezel. 3. Confirm that all cables are attached firmly. 4. Power up the system and verify that the system fan and processor fan are operating. Proceed to the section "Updating the BIOS" later in this chapter. 20