HP LJ476UT User Manual - Page 96
from the system, On the bottom of the system board, disconnect the battery connector cable
![]() |
View all HP LJ476UT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
6. If removing the system board from model 4730s, remove the three Torx T8M2.0×5.0 screws (1) that secure the system board to the computer, and the two Torx T8M2.0×5.0 screws (2) that secure the hard drive extension board to the computer. 7. Lift the optical drive connector latch (3), and then disconnect the optical drive cable (4). 8. Lift the right side of the system board upward (5), and then lift it away enough to gain access to the cables underneath (6). 9. On the bottom of the system board, disconnect the battery connector cable (1) from the system board. 10. Disconnect the smaller power cable (2) and the larger power cable (3) from the system board. 11. Lift the system board out of the computer (4). Reverse this procedure to install the system board. 88 Chapter 4 Removal and replacement procedures
![](/manual_guide/products/hewlettpackard-lj477ut-user-manual-bf6e614/96.png)