HP LaserJet 9040/9050 Service Manual - Page 152
Low-voltage power supply,
View all HP LaserJet 9040/9050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Low-voltage power supply 1 Remove the back cover. See page 109. 2 Remove the large cable connector (callout 1) from the DC controller. 3 Unroute the cable from the cable guides (callout 2). 12 2 Figure 80. Low-voltage power supply (1 of 2) 4 Unplug one standard cable connector (callout 3) from the low-voltage power supply. 5 Unplug one molex cable connector (callout 4) by pulling and releasing the tab on the side of the connector. 6 Unplug two molex cable connectors (callout 5) by pressing and releasing the tabs on the side of the connectors. 7 Remove four gold screws (callout 6). 8 Remove the low-voltage power supply. 42 32 62 52 Figure 81. Low-voltage power supply (2 of 2) 136 Chapter 6 Removal and replacement
136
Chapter 6 Removal and replacement
Low-voltage power supply
1
Remove the back cover. See page 109.
2
Remove the large cable connector (callout 1) from the DC controller.
3
Unroute the cable from the cable guides (callout 2).
Figure 80.
Low-voltage power supply (1 of 2)
4
Unplug one standard cable connector (callout 3) from the low-voltage power supply.
5
Unplug one molex cable connector (callout 4) by pulling and releasing the tab on the side of the
connector.
6
Unplug two molex cable connectors (callout 5) by pressing and releasing the tabs on the side of
the connectors.
7
Remove four gold screws (callout 6).
8
Remove the low-voltage power supply.
Figure 81.
Low-voltage power supply (2 of 2)
2
2
2
1
2
2
2
2
6
4
3
5