HP LaserJet Pro CM1415 HP LaserJet Pro CM1410 - Software Technical Reference - Page 164
Network Setup menu
View all HP LaserJet Pro CM1415 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 164 highlights
Network Setup menu In the following table, items that have an asterisk (*) indicate the factory default setting. Menu item Wireless Menu (wireless models only) Sub-menu item Wireless Setup Wizard Wi-Fi Protected Setup TCP/IP Config Run Network Test Turn Wireless On/Off Automatic* Manual Auto Crossover Network Services Link Speed Restore Defaults On* Off IPv4 IPv6 Automatic* 10T Full 10T Half 100TX Full 100TX Half Description Guides you through the steps to set up the product on a wireless network If your wireless router supports this feature, use this method to set up the product on a wireless network. This is the simplest method. Tests the wireless network and prints a report with the results. Enables or disables the wireless network feature. Automatic: The product automatically configures all the TCP/IP settings via DHCP, BootP or AutoIP. Manual: You can manually configure the IP address, subnet mask, and default gateway. The control panel prompts you to specify values for each address section. As each address is completed, the product prompts for address confirmation before moving to the next one. After all three addresses are set, the network reinitializes. Enables or disables the use of a standard 10/100 network cable when the product is directly connected to a computer. Enable or disable the IPv4 and IPv6 protocols. By default, each protocol is enabled. Sets the link speed manually if needed. After setting the link speed, the product automatically restarts. Resets all network configurations to their factory defaults. 144 Chapter 6 Solve problems ENWW