HP Latex 2700 User Guide 2 - Page 7

Before inflating, use the pneumatic gun to blow air around the valve area to remove any dirt.

Get HP Latex 2700 PDF manuals and user guides View all HP Latex 2700 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

4. Move the rolls to the center of the printer. Accurately position each roll following one of the spindle marks. The input and output rolls should be positioned identically on their respective parts of the spindle. 5. Inflate the valves at both ends by connecting the air gun to the pneumatic connectors. TIP: Before inflating, use the pneumatic gun to blow air around the valve area to remove any dirt. WARNING! The air gun provided with the printer is only intended to inflate the spindle. When recommended to use for cleaning purposes, make sure to do so according to local regulations since additional safety provisions may apply. Dual-roll split-spindle specifications Characteristic Minimum roll width Maximum roll width Minimum gap between rolls Maximum roll diameter Maximum total weight of both rolls Specification 635 mm (25 in) 2 × 1.52 m (2 × 60 in) 134 mm (5.3 in) 400 mm (15.75 in) 2 × 200 kg (2 × 440 lb) 4 Chapter 3 Load rolls onto the split spindles

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
4.
Move the rolls to the center of the printer. Accurately position each roll following one of the spindle marks.
The input and output rolls should be positioned identically on their respective parts of the spindle.
5.
Inflate the valves at both ends by connecting the air gun to the pneumatic connectors.
TIP:
Before inflating, use the pneumatic gun to blow air around the valve area to remove any dirt.
WARNING!
The air gun provided with the printer is only intended to inflate the spindle. When
recommended to use for cleaning purposes, make sure to do so according to local regulations since
additional safety provisions may apply.
Dual-roll split-spindle specifications
Characteristic
Specification
Minimum roll width
635 mm (25 in)
Maximum roll width
2 × 1.52 m (2 × 60 in)
Minimum gap between rolls
134 mm (5.3 in)
Maximum roll diameter
400 mm (15.75 in)
Maximum total weight of both rolls
2 × 200 kg (2 × 440 lb)
4
Chapter 3
Load rolls onto the split spindles