HP Latex 360 Users Guide - Page 77
substrate is straight., Tape the leading edge of the substrate to the core in the center
View all HP Latex 360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
NOTE: If you are loading the take-up reel during printing, you do not need to pull the substrate taut. Tape the substrate to the core when an adequate length of substrate has fed from the printer after printing begins. WARNING! Do not touch the printer's curing enclosure, which could be hot. Risk of burns For more safety information, please see Safety precautions on page 3 11. Adjust the position of the core on the take-up reel so that it is aligned with the substrate. 12. Tape the leading edge of the substrate to the core in the center, then at each side. Make sure that the substrate is straight. NOTE: Depending on whether you want to print the images facing in or out, place the tape accordingly. See below. ENWW The take-up reel 71
NOTE:
If you are loading the take-up reel
during
printing, you do not need to pull the substrate taut.
Tape the substrate to the core when an adequate length of substrate has fed from the printer after
printing begins.
WARNING!
Do not touch the printer's curing enclosure, which could be hot.
Risk of burns
For more safety information, please see
Safety precautions
on page
3
11.
Adjust the position of the core on the take-up reel so that it is aligned with the substrate.
12.
Tape the leading edge of the substrate to the core in the center, then at each side. Make sure that the
substrate is straight.
NOTE:
Depending on whether you want to print the images facing in or out, place the tape
accordingly. See below.
ENWW
The take-up reel
71